Juniper JUNOS - NETWORK OPERATION GUIDE REV1 Network Operation Manual page 619

Slot 1 information:
State
SPP Temperature
SPR Temperature
Total CPU DRAM
Total SSRAM
Internet Processor II
For M160 routers:
Slot 0 information:
State
SPP Temperature
SPR Temperature
Total CPU DRAM
Total SSRAM
Internet Processor I
Start time:
Uptime:
Slot 1 information:
State
[...Output truncated...]
Slot 2 information:
State
[...Output truncated...]
Slot 3 information:
State
[...Output truncated...]
Packet scheduling mode : Disabled
In addition to the command output displayed for the show chassis sfm command,
the show chassis sfm detail command displays the temperature of air passing by
the SPP and SPR cards (the two SFM serial components), in degrees Centigrade. It
displays the total CPU DRAM and SRAM being used by the SFM processor. The
command output displays the time that the SFM became active and how long the
SFM has been up and running. A small uptime means that the SFM came online a
short time ago and could indicate a possible SFM error condition.
To display the status of a particular SFM, use the following CLI command:
user@host> show chassis sfm sfm-slot
To display detailed status information about a particular SFM, use the following CLI
command:
user@host> show chassis sfm detail sfm-slot
Chapter 44: Monitoring Redundant SFMs
Online - Standby
41 degrees C / 105 degrees F
40 degrees C / 104 degrees F
64 MB
8 MB
Version 1, Foundry IBM, Part number 9
Online
39 degrees C / 102 degrees F
41 degrees C / 105 degrees F
64 MB
4 MB
Version 1, Foundry IBM, Part number 3
2002-06-27 18:49:44 PDT
68 days, 4 hours, 55 minutes, 5 seconds
Online
Offline
Online
Monitoring Redundant SFM Status
!
583