Using The Basic Monitoring Method - Juniper JUNOS - NETWORK OPERATION GUIDE REV1 Network Operation Manual

Using the Basic Monitoring Method

To monitor router components, follow these steps:
Steps To Take
1. Check the Router Component Status on page 56
2. Gather Component Alarm Information on page 60
3. Verify the Component Problem on page 84
4. Fix the Problem on page 84
5. Contact JTAC on page 84
6. Return the Failed Component on page 86
Chapter 11: Understanding the Method and Tools for Monitoring Router Components
Command
show log chassisd
request support information
Description
Displays the contents of the chassis daemon (
log file that keeps track of the state of each chassis
component
To monitor the file in real time, use the
chassisd
CLI command. This command displays
start chassisd
the new entries in the file until you stop monitoring by
using the monitor stop chassisd
Use this command when you contact JTAC about your
component problem. This command is the equivalent of
using the following CLI commands (see "Contact JTAC"
on page 35):
!
show system uptime
!
show version detail
!
show system core-dumps
!
show chassis hardware
!
show system processes extensive
!
show pfe statistics error
!
show chassis routing-engine
!
show chassis environment
!
show chassis firmware
!
show chassis fpc detail
!
show system boot-messages
!
show system storage
!
show system virtual-memory
!
show system buffer
!
show system queues
!
show system statistics
!
show configuration | except SECRET-DATA
!
show interfaces extensive (for each configured
interface)
!
show chassis hardware extensive
Using the Basic Monitoring Method
)
chassisd
monitor
CLI command.
!
55