Table of Contents
Advertisement
Chapter 4
Installing Modules
Overview
This chapter describes how to install and remove modules. For information about
managing installed modules, see JUNOSe System Basics Configuration Guide, Chapter 6,
Managing Modules.
This chapter contains the following sections:
Overview on page 27
Safety Guidelines on page 38
Installing an SRP Module or SFM Module on page 38
Installing an IOA Shelf on page 40
Installing a Line Module or an IOA on page 41
Removing Modules and IOAs on page 42
Installing and Removing SFPs on page 44
The Next Step on page 46
Slots for line modules, switch route processor (SRP) modules, and switch fabric
module (SFM) modules are located in the front of the router, while slots for
input/output adapters (IOAs) and SRP IOAs are located in the rear.
In the E320 Broadband Services Router, modules mount vertically in a 15–slot
chassis, numbered left to right (0–16). See Figure 12 on page 28 and Figure 13
on page 29 for front and rear views of the router.
27
Overview
Advertisement
Table of Contents
Troubleshooting
