Installing Modules; Overview - Juniper E-Series Installation And User Manual

Installing Modules

Overview

This chapter describes how to install and remove E-series modules.
For information about managing installed modules, see
Basics Configuration Guide, Chapter 5, Managing Line Modules and
SRP Modules.
Topic
Overview
Safety Guidelines
Installing SRP I/O and SRP Modules
Installing Line and I/O Modules
Removing a Module
Installing Components for Line Module Redundancy
Configuring Line Module Redundancy
The Next Step
Line module slots are located in the front of each E-series chassis, while
I/O module slots are located in the rear. See
Overview, for front and rear views of E-series routers.
In ERX-14xx models, modules mount vertically in a chassis with 14 slots.
In ERX-7xx models and ERX-310 routers, modules mount horizontally
in a chassis with 7 slots and 3 slots, respectively. See
5
E-Series System
Page
5-10
5-13
5-16
5-16
Chapter 1, E-Series
Figure 5-1.
5-1
5-7
5-7
5-11