Installing Modules; Overview; Chapter 5 Installing Modules - Juniper E Series Hardware Manual

Chapter 5

Installing Modules

Overview

This chapter describes how to install and remove E-series modules.
For information about managing installed modules, see
Configuration Guide, Chapter 5, Managing Line Modules and SRP
Topic
Overview
Safety Guidelines
Installing SRP I/O and SRP Modules
Installing Line and I/O Modules
Removing a Line Module, SRP Module, or SRP I/O Module
Installing Components for Line Module Redundancy
Configuring Line Module Redundancy
The Next Step
Line module slots are located in the front of each E-series chassis, while I/O module
slots are located in the rear. See Chapter 1, E-series Overview, for front and rear
views of E-series routers.
In ERX-14xx models, modules mount vertically in a chassis with 14 slots. In
ERX-7xx models and ERX-310 routers, modules mount horizontally in a chassis
with 7 slots and 3 slots, respectively. See Figure 21.
JUNOSe System Basics
Modules.
Page
39
44
44
47
48
50
53
53

Overview

!
39