Task 1: Turn Off All Router Power; Task 2: Connect The Grounding Cables - Juniper E120 - RELEASE 11.1.X HARDWARE GUIDE 3-25-2010 Hardware Manual

E120 and E320 11.1.x Hardware Guide
Figure 27: PDU

Task 1: Turn Off All Router Power

Before starting to cable the router, push all router power switches to OFF to turn off
the router.

Task 2: Connect the Grounding Cables

The router has two grounding studs located in the rear of the chassis, near the power
inputs. Each stud provides grounding for a single power unit.
To ground each power unit:
1.
2.
54
Cabling the Router for Power
Locate the grounding studs on the router (Figure 27 on page 54).
Remove the nuts and locking washers from the grounding studs.