Dell PowerConnect J-EX4500 Hardware Manual page 142

Dell PowerConnect J-Series J-EX4500 Ethernet Switch Hardware Guide
Related
Documentation
126
If you installed the switch with square-hole cage nuts, a flat-blade (-) screwdriver to
remove the cage nuts
A labeled bag to hold the removed screws—and the removed cage nuts and washers,
if applicable
To remove a J-EX4500 switch from a rack:
Use the appropriate Phillips (+) screwdriver to remove the mounting screws that
1.
attach the chassis front-mounting brackets to the rack.
Place the removed screws in a labeled bag. You will need them when you reinstall
2.
the chassis.
Lift the chassis from the rack and carefully move the chassis to its new location.
3.
If you installed the switch with cage nuts:
4.
Remove the cage nuts from the rack.
a.
Use Figure 52 on page 126 or Figure 53 on page 126 to help you with cage-nut removal.
Figure 52: Removing a Round-Hole Cage Nut (Clip Nut)
Figure 53: Removing a Square-Hole Cage Nut
Place the removed cage nuts in the labeled bag with the screws and washers. You
b.
will need them when you reinstall the chassis.
Mounting a J-EX4500 Switch on page 78