Table of Contents
Advertisement
Dell PowerConnect J-Series J-EX4500 Ethernet Switch Hardware Guide
Packing a J-EX4500 Switch or Component for Shipping
Packing a J-EX4500 Switch for Shipping
154
Uplink module—The serial number ID label is on the circuit board. See "Removing an
Uplink Module from a J-EX4500 Switch" on page 131.
Virtual Chassis module—The serial number ID label is on the circuit board towards
the rear of the module. Figure 65 on page 154 shows the location of the serial number
ID label. See Removing a Virtual Chassis Module from a J-EX4500 Switch.
Figure 65: Location of the Serial Number ID Label on the Virtual Chassis
Module Used in a J-EX4500 Switch
Rear
Front
If you are returning a J-EX4500 switch or component for repair or replacement, pack the
item as described in this topic.
Before you begin packing the switch or component:
Ensure that you have retrieved the original shipping carton and packing materials.
Contact Dell if you do not have these materials, to learn about approved packing
materials. See "Returning Items for Warranty Repair or Credit" on page 149.
Ensure you understand how to prevent ESD damage. See "Prevention of Electrostatic
Discharge Damage on J-EX Series Switches" on page 186.
This topic describes:
Packing a J-EX4500 Switch for Shipping on page 154
1.
Packing J-EX4500 Switch Components for Shipping on page 156
2.
If you need to transport the switch to another location or return the switch, you need to
pack the switch securely in its original packaging to prevent damage during transportation.
Before you pack the switch:
Serial number
ID label
Advertisement
Table of Contents
