Mounting A J-Ex4500 Switch On Four Posts In A Rack Or Cabinet; Connecting Ac Power To A J-Ex4500 Switch - Dell PowerConnect J-EX4500 Hardware Manual

Related
Documentation

Mounting a J-EX4500 Switch on Four Posts in a Rack or Cabinet

Figure 28: Mounting the Switch on Two Posts in a Rack
Have a second person secure the switch to the rack with the appropriate hardware:
8.
If you installed cage nuts, install the appropriate screws with washers through the
rack holes and into the cage nuts in each post.
If your rack has threaded holes, install screws into the aligned rack holes in each
post.
Tighten the screws.
9.
Ensure that the switch chassis is level by verifying that all screws on one side of the
10.
rack are aligned with the screws on the other side.
We recommend that you insert dust covers in any unused ports.
11.
Connecting Earth Ground to a J-EX Series Switch on page 99
Connecting AC Power to a J-EX4500 Switch on page 101
Connecting and Configuring a J-EX Series Switch (CLI Procedure) on page 117
Connecting and Configuring a J-EX Series Switch (J-Web Procedure) on page 118
Rack-Mounting and Cabinet-Mounting Warnings for J-EX Series Switches on page 173
You can mount a J-EX4500 switch on four posts of a 19-in. rack or cabinet by using the
separately orderable four-post rack-mount kit. (The remainder of this topic uses "rack"
to mean "rack or cabinet.")
You can mount the switch on two posts in either a two-post rack or a four-post rack by
using the mounting brackets provided with the switch. See "Mounting a J-EX4500 Switch
on Two Posts in a Rack or Cabinet" on page 78.
Mounting rack
Mounting bracket
Chapter 9: Installing the Switch
81