Table of Contents
Advertisement
To install a transceiver in a J-EX Series switch:
CAUTION:
To avoid electrostatic discharge (ESD) damage to the transceiver,
do not touch the connector pins at the end of the transceiver.
Remove the transceiver from its bag.
1.
Check to see whether the transceiver is covered by a rubber safety cap. If it is not,
2.
cover the transceiver with a rubber safety cap.
WARNING:
inserting or removing a cable. The rubber safety cap keeps the port clean
and prevents accidental exposure to laser light.
If the port in which you want to install the transceiver is covered with a dust cover,
3.
remove the dust cover and save it in case you need to cover the port later. If you are
hot-swapping a transceiver, wait for at least 10 seconds after removing the transceiver
from the port before installing a transceiver.
Using both hands, carefully place the transceiver in the empty port. The connectors
4.
must face the switch chassis.
CAUTION:
Before you slide the transceiver into the port, ensure the
transceiver is aligned correctly. Misalignment might cause the pins to
bend, making the transceiver unusable.
Slide the transceiver in gently until it is fully seated.
5.
Remove the rubber safety cap when you are ready to connect the cable to the
6.
transceiver.
WARNING:
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables
connected to transceivers emit laser light that can damage your eyes.
Figure 40: Installing a Transceiver in a J-EX Series Switch
Do not leave a fiber-optic transceiver uncovered except when
Do not look directly into a fiber-optic transceiver or into the
Chapter 10: Installing Switch Components
97
Advertisement
Table of Contents
