Table of Contents
Advertisement
Dell PowerConnect J-Series J-EX4500 Ethernet Switch Hardware Guide
Table 5: LCD Panel Menu Options in J-EX4500 Switches (continued)
Menu
Purpose
MAINT
Provides options you can
(Maintenance
use to configure and
Menu)
troubleshoot the switch.
16
Options
The Maintenance menu has the following options to configure and
troubleshoot the switch:
SYSTEM HALT?—Choose one of the following:
Press
to halt the switch. Press
Enter
Press
to go to the next option in the Maintenance menu.
Menu
SYSTEM REBOOT?—Choose one of the following:
Press
to reboot the switch. Press
Enter
Press
Menu
to go to the next option in the Maintenance menu.
LOAD RESCUE?—Choose one of the following:
Press
to roll back the switch to the previous valid configuration.
Enter
Press
Enter
again to confirm the rollback.
Press
to go to the next option in the Maintenance menu.
Menu
REQUEST VC PORT?—Choose one of the following:
Press
to configure an uplink module port or a network port to be a
Enter
Virtual Chassis port (VCP), or to delete a VCP from the switch
configuration. (When you delete the VCP, the port is reset to an uplink
module port or network port.).
NOTE:
This option is supported only on J-EX4500 switches in a Virtual Chassis
configuration and not on J-EX4500 standalone switches.
Press
Menu
to go to the next option in the Maintenance menu.
FACTORY DEFAULT?—Choose one of the following:
Press
to restore the switch to the factory default configuration.
Enter
Press
Enter
again to confirm the restoration. The LCD flashes a success
or failure message and returns to the Idle menu.
Press
to go to the next option in the Maintenance menu.
Menu
ENTER EZSETUP?—Choose one of the following:
Press
to launch EZSetup. Press
Enter
EZSetup configures DHCP and enables the J-Web user interface on the
switch. The LCD flashes a success or failure message for approximately
10 seconds and returns to the Idle menu.
Press
to go to the next option in the Maintenance menu.
Menu
NOTE:
You can use EZSetup only on a standalone switch that is in the factory
default configuration.
For information about EZSetup, see "Connecting and Configuring a J-EX
Series Switch (J-Web Procedure)" on page 118.
EXIT MAINT MENU?—Choose one of the following:
Press
to exit the Maintenance menu.
Enter
Press
Menu
to return to the SYSTEM HALT option.
You can disable the Maintenance menu or the options in the Maintenance
menu in the LCD panel. See instructions for configuring the LCD panel in the
Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos
OS at
http://www.support.dell.com/manuals
again to confirm the halt.
Enter
again to confirm the reboot.
Enter
again to confirm the launch.
Enter
.
Advertisement
Table of Contents
