Table of Contents
Advertisement
Disconnect power from the switch by performing one of the following tasks:
3.
If the AC power source outlet has a power switch, set it to the OFF (0) position.
If the AC power source outlet does not have a power switch, gently pull out the
male end of the jumper cable or power cord connected to the power source outlet.
Turn the adjustment nut of the power cord retainer counterclockwise till you can see
4.
the jumper cable or power cord. Pull the cord from the slot in the adjustment nut.
Remove the female end of the jumper cable or power cord from the AC appliance
5.
inlet on the power supply faceplate.
Push the power cord retainer clip to one side of the appliance inlet. Squeeze the two
6.
sides of the power cord retainer clip, and pull the L-shaped ends of the clip from the
holes on each side of the AC appliance inlet to completely remove the power retainer
clip.
Push the ejector lever until the power supply is unseated.
7.
Grasp the power supply handle and pull firmly to slide the power supply halfway out
8.
of the chassis.
Taking care not to touch power supply pins, leads, or solder connections, place one
9.
hand under the power supply to support it. Grasp the power supply handle with your
other hand and pull the power supply completely out of the chassis.
Place the power supply in the antistatic bag or on the antistatic mat placed on a flat,
10.
stable surface.
If you are not replacing the power supply, install the cover panel over the slot.
11.
Figure 54: Removing a Power Supply from a J-EX4500 Switch
Related
Installing a Power Supply in a J-EX4500 Switch on page 88
Documentation
Installing and Removing J-EX4500 Switch Hardware Components on page 87
AC Power Supply in J-EX4500 Switches on page 21
Field-Replaceable Units in J-EX4500 Switches on page 18
AC Power Cord Specifications for a J-EX4500 Switch on page 65
Rear Panel of a J-EX4500 Switch on page 9
Ejector
lever
Chapter 14: Removing Switch Components
129
Advertisement
Table of Contents
