Connecting A J-Ex Series Switch To A Management Console - Dell PowerConnect J-EX4500 Hardware Manual

Dell PowerConnect J-Series J-EX4500 Ethernet Switch Hardware Guide
Related
Documentation

Connecting a J-EX Series Switch to a Management Console

104
Connect the other end of the Ethernet cable to the management device.
2.
Figure 45: Connecting a J-EX Series Switch to a Network for Out-of-Band
Management
Connecting a J-EX Series Switch to a Management Console on page 104
Management Port Connector Pinout Information for a J-EX4500 Switch on page 34
You can configure and manage a J-EX Series switch using a dedicated console. Every
J-EX Series switch has a console port with an RJ-45 connector. Use the console port to
connect the J-EX Series switch to the management console or to a console server. The
console port accepts a cable with an RJ-45 connector.
Ensure that you have an Ethernet cable with an RJ-45 connector available. An RJ-45
cable and an RJ-45-to-DB-9 serial port adapter are supplied with the switch.
Figure 46 on page 104 shows the RJ-45 connector of the Ethernet cable supplied with the
switch.
Figure 46: Ethernet Cable Connector
NOTE: If your laptop or PC does not have a DB-9 male connector pin and you
want to connect your laptop or PC directly to a J-EX Series switch, use a
combination of the RJ-45-to-DB-9 female adapter supplied with the switch
and a USB-to-DB-9 male adapter. You must provide the USB-to-DB-9 male
adapter.