Chapter 4: Install A S3100 Series System; Unpacking A S3100 Series Switch - Dell S3100 Series Installation Manual

To install a S3100 series system, Dell Networking recommends completing the installation procedures in the order presented.
Always handle the system and its components with care. Avoid dropping the system or its field replaceable units (FRUs).
WARNING: ESD damage can occur if components are mishandled. Always wear an ESD-preventive wrist or heel
ground strap when handling the system and its components. As with all electrical devices of this type, take all
the necessary safety precautions to prevent injury when installing this system.
Topics:
•

Unpacking a S3100 Series Switch

• Storing Components
• Installing a Power Supply
• Replacing a Power Supply
•
Installing a Fan Tray
• Replacing a Fan Tray
• Installing a Plug-In Module (Optional)
• Install Rack or Cabinet Hardware
• Installing the Dell ReadyRails System
• Configuring a Two-Post Flush-Mount
• Configuring a Two-Post Center-Mount
• Configuring a Four-Post Thread
• Installing a 1U Two-Post
• Installing a 1U Front-Rack
• Connecting the Stacking Ports (Optional)
• Powering Up
• Accessing the Console
Unpacking a S3100 Series Switch
To unpack your switch, follow these steps.
NOTE: Before unpacking the switch, inspect the container and immediately report any evidence of damage.
When unpacking each S3100 series switch, make sure that the following items are included:
● One S3100 series switch.
● One RJ-45 to DB-9 female cable.
● One Dell ReadyRails™ kit for rack installation, two mounting brackets, bolts, and cage nuts.
● One set of self-adhesive rubber pads for free-standing installation (four pads are included).
● One PSU.
● Getting Started Guide.
● Safety and Regulatory Information.
● Warranty and Support Information.
● Software License Agreement.
1. Place the container on a clean, flat surface and cut all straps securing the container.
2. Open the container or remove the container top.
3. Carefully remove the switch from the container and place it on a secure and clean surface.
4. Remove all packing material.
5. Inspect the product and accessories for damage.
28 Install a S3100 Series System
Install a S3100 Series System
4