Hardware Installation - Kyocera Ai5555 Instruction Handbook Manual

Installation

Hardware Installation

DO NOT apply power to the NC-2 until all hardware installation and
software configuration steps are completed. Use the following steps to
connect your printer controller to the NC-2 print server.
Connecting the Ethernet Network to the NC-2
Connect your Ethernet network by using either the 10BaseT Ethernet
interface or the Thinnet Ethernet interface.
Using the 10BaseT Ethernet Interface
This network connection uses a 4-wire RJ cable to plug into the RJ45
network connector located on the back panel of the print controller. Once
you make the connection, you are ready to configure the network protocol
(see instructions on the next page).
Using a Thinnet Ethernet Interface
The Thinnet Ethernet wires use a BNC T-connector (not included in your
package) to plug into the BNC port on the NC-2 (marked Thinnet). Thin
Ethernet cable is 1/4-inch coaxial cable (usually RG-58/U) that uses the
cylindrical BNC T-connector to attach to the BNC port.
The following illustration shows how the proper BNC connection looks.
BNC Connection
IMPORTANT: Use the T-Connector when making the BNC connection,
making sure the T-connector is directly connected to the port marked
Thinnet; otherwise, the connection will not work.
2-4 Installation