Led Patterns - Brocade Communications Systems PowerConnect Brocade 6505 Hardware Reference Manual

3
LED activity interpretation
Figure 4
1
FIGURE 4

LED patterns

Table 1
TABLE 1
LED name
Power Status
(green)
System Status
(bicolor)
Ethernet
Speed (green)
Ethernet
Activity/Link
(amber)
20
shows the LEDs on the nonport side of the switch.
Power supply and fan assembly #1 status LED
LEDs on the nonport side of Brocade 6505
describes the port side LEDs and their behavior.
Port side LED patterns during normal operation
LED color
No light
Steady green
No light
Steady green
Steady amber (for
more than five
seconds)
Blinking amber
No light
Steady green
No light
Steady amber
Blinking amber
Status of hardware
System is off or there is an
internal power supply failure.
System is on and power supplies
are functioning properly.
System is off or there is no
power.
System is on and functioning
properly.
A system fault has occurred.
This LED displays steady amber
during POST; this is normal and
does not indicate a fault.
Attention is required. A number
of factors can cause this status,
including a single power supply
failure, a fan failure, or one or
more environmental ranges has
been exceeded.
Port speed is 10 Mbps.
Port speed is 100 Mbps.
There is no link.
There is a link.
There is link activity (traffic).
1
Recommended action
Verify the system is powered on (power
supply switches to I), the power cables
are attached, and your power source is
live.
Otherwise, contact your switch service
provider.
No action required.
Verify the system is on and has
completed booting.
No action required.
Check the failure indicated on the
system console.
Contact your switch service provider.
Check the management interface and
the error log for details on the cause of
status.
Contact your switch service provider.
No action required.
No action required.
Verify that the Ethernet cable is
connected correctly.
No action required.
No action required.
Brocade 6505 Hardware Reference Manual
53-1002449-01