Led Patterns - Brocade Communications Systems VA-40FC Hardware Reference Manual

LED Patterns

Table 1
TABLE 1
LED Name
Power Supply
Status (right)
Power Status
System Status
Ethernet
Speed
Ethernet Link
Brocade VA-40FC Hardware Reference Manual
53-1001540-04
describes the LEDs and their actions on the switch.
Brocade VA-40FC LED Patterns During Normal Operation
LED Color
No light
Steady green
No light
Steady green
No light
Steady green
Steady amber (for
more than five
seconds)
Flashing
amber/green
No light
Steady green
No light
Steady amber
Flickering amber
Status of Hardware
Primary power cord is disconnected
or is not actively powered, or power
supply has failed.
Power supply is operating normally.
System is off or there is an internal
power supply failure.
System is on and power supplies are
functioning properly.
System is off, boot is not complete,
or boot failed.
System is on and power supplies are
functioning properly.
Boot failed, the system is faulty.
Attention is required. A number of
variables can cause this status
including a single power supply
failure, a fan failure, or one or more
environmental ranges has exceeded.
Port speed is 10 Mbps.
Port speed is 100 Mbps.
There is no link.
There is a link.
There is link activity (traffic).
LED activity interpretation
Recommended Action
Verify the power supply is on and
seated and the power cord is
connected to a functioning power
source.
No action required.
Verify the system is on. If the system
is on, the unit is faulty.
Contact Technical Support.
No action required.
Verify the system is on and has
completed booting.
No action required.
Perform the following steps:
Connect a serial cable to the system.
Reboot the system.
Check the failure indicated on the
system console.
Contact Technical Support.
Check the management interface
and the error log for details on the
cause of status.
Contact Technical Support if
required.
No action required.
No action required.
Verify the Ethernet cable is
connected correctly.
No action required.
No action required.
3
21