4
Removing and replacing a power supply and fan assembly
Time required
Replacing a power supply and fan assembly in the Brocade 6505 should require less than two
minutes to complete.
Items required
The following items are required to replace a power supply and fan assembly:
•
•
Removing a power supply and fan assembly
Refer to
Complete the following steps to remove a combined power supply and fan assembly from a
Brocade 6505.
1. If the Brocade 6505 has only one power supply and fan assembly, then the switch must be
2. If the Brocade 6505 has two power supply and fan assemblies, skip to
3. Power off the assembly to be replaced by switching the AC power switch to the O symbol.
4. Unplug the power cord from the power supply and fan assembly that is being replaced.
5. Using a Phillips screwdriver, unscrew the captive screw.
6. Remove the power supply and fan assembly from the chassis by pulling the handle out and
7.
30
POWER SUPPLY
Unit: 1
Power Source:
Time Awake:
Power Supply #1 is OK
Power Supply #2 is absent
<additional output truncated>
br6505:admin>
New power supply and fan assembly
A #1 Phillips screwdriver
Figure 8
for this procedure.
powered off prior to replacing the assembly. If the Brocade 6505 has two power supply and fan
assemblies installed, verify that the other power supply and fan assembly (the one not being
replaced) has been powered on for at least four seconds and has a steady green LED.
6505 has only one power supply and fan assembly, enter the sysShutDown command before
powering off the assembly to maintain the reliability of the system.
If the Brocade 6505 has two power supply and fan assemblies,the fans in the second power
supply will automatically switch to high speed to maintain adequate cooling.
away from the chassis.
Note the part number on the assembly just removed.
AC
0 days
Brocade 6505 Hardware Reference Manual
step
3. If the Brocade
53-1002449-01