Brocade Communications Systems PowerConnect Brocade 6505 Hardware Reference Manual page 40

4
Removing and replacing a power supply and fan assembly
1
2
3
4
FIGURE 7
CAUTION
Disassembling any part of the power supply voids the part warranty and regulatory certifications.
There are no user-serviceable parts inside the power supply and fan assembly.
CAUTION
The cooling system relies on pressurized air; if you are using redundant power supply and fan
assemblies, do not leave either of the power supply and fan assembly slots empty longer than
two minutes when the Brocade 6505 is operating. If one power supply and fan assembly fails,
leave the power supply and fan assembly in the Brocade 6505 until it can be replaced.
If you are using only one power supply and fan assembly, be sure that the slot filler panel is in
place. If that power supply fails, the switch will turn off.
ATTENTION
If you are using two power supply and fan assemblies, maintain both power supply and fan
assemblies in operational condition to provide redundancy.
Table 4
required, if any.
28
1
Filler panel
Power supply and fan assembly 1
Power supply and fan assembly LED
On/off switch
Nonport side of the Brocade 6505
describes the power supply and fan assembly status LED colors, behaviors, and actions
2 3 4 5
7
5 Power plug receptacle (with plug retainer)
6 Thumbscrew
7 Handle
Brocade 6505 Hardware Reference Manual
6
53-1002449-01