Table of Contents
Advertisement
available on the system. In this dialog, select Add to open another dialog in which to
enter ZFCP parameters.
To make a ZFCP disk available for the SUSE Linux Enterprise Server installation,
choose an available Channel Number from the drop-down list. Get WWPNs (World
Wide Port Number) and Get LUNs (Logical Unit Number) return lists with available
WWPNs and FCP-LUNs, respectively, to choose from. When completed, exit the ZFCP
dialog with Next and the general hard disk configuration dialog with Finish to continue
with the rest of the configuration.
TIP: Adding DASD or zFCP Disks at a Later Stage
Adding DASD or zFCP disks is not only possible during the installation workflow,
but also when the installation proposal is shown. To add disks at that stage,
click Expert and scroll down. The DASD and zFCP entries are shown at the very
bottom.
After adding the disks, reread the partition table. Return to the installation
proposal screen and choose Partitioning then select Reread Partition Table.
This reads the new partition table and resets any previously entered information.
6.9 Installation Mode
After a system analysis where YaST probes for storage devices and tries to find other
installed systems on your machine, the installation modes available are displayed.
New installation
Select this option to start a new installation from scratch.
Update
Select this option to update to a newer version. For more information about system
update, see
Chapter 7, Updating SUSE Linux Enterprise
Repair Installed System
Choose this option to repair a damaged system that is already installed. More infor-
mation is available in Section "Recovering a Corrupted System" (Chapter 7,
Common Problems and Their Solutions, ↑System Analysis and Tuning Guide).
(page 125).
Installation with YaST
101
Advertisement
Table of Contents
