Da1X Errors - Novell GROUPWISE 7 - TROUBLESHOOTING 1 Troubleshooting Manual

7.18 DA1x Errors

DA10 Cannot read post office configuration information
Possible Cause: An error was detected while reading POA configuration information from the
DA12 Invalid application configuration name
Possible Cause: The eDirectory distinguished name (DN) specified on the command line when
DA13 /name switch required
Possible Cause: An eDirectory distinguished name (DN) was not specified where one is
Possible Cause: This post office has been configured to run more than one POA process for it.
118 GroupWise 7 Troubleshooting 1: Error Messages
"DA10 Cannot read post office configuration information" on page 118
"DA12 Invalid application configuration name" on page 118
"DA13 /name switch required" on page 118
"DA17 /user and /password switches required for this configuration" on page 119
Source: GroupWise engine; Post Office Agent.
Explanation: Error reading post office configuration information.
post office database (wphost.db). The post office database might be in an
inconsistent state.
Action: Start the POA with /noconfig, and validate the post office database. See
"Maintaining Domain and Post Office
GroupWise 7 Administration
Source: GroupWise engine; Post Office Agent.
Explanation: Invalid application name.
starting the POA was invalid. The DN might be misspelled.
Action: Specify a valid DN. A list of valid DNs for a given post office can be obtained
by failing to specify one on the POA command line (with the
when the system is configured so that one is required. You can then choose one
from the list. A DN must be specified in a system that has been configured to
run more than one POA process for a single post office. In that case, the DN is
used by the POA to find configuration information for a specific POA process
(such as TCP/IP address, port, and other configuration information).
Source: GroupWise engine; Post Office Agent.
Explanation: Ambiguous application name.
required. Your system is configured in a way that requires the
be specified when starting the POA.
The DN is used by the POA to identify the configuration information and
options that it should use when running.
Action: The /name switch should be used in conjunction with one of the DNs specified
in the error message.
Databases" in "Databases" in the
Guide.
/name switch)
/name switch to