Before You Begin - Dialogic IMG 1004 Installation And Setup Manual

Installation and Setup

Before You Begin

 Verify you have unpacked, mounted, and connected power to the GCEMS server
(Linux Server) and IMG 1004. See the manufacturer's instructions for installation
procedures.

Verify that you have acquired IP Addresses for the IMG 1004 and the GCEMS
server.

Verify that you have the correct MAC address from the IMG 1004. The MAC
address is displayed on a label located on the rear of IMG 1004 chassis.
 Verify the latest IMG 1004 system software file has been acquired. This file is on
the software discs supplied or can be downloaded after logging in to the Dialogic
Technical Support website. http://www.dialogic.com/support and selecting
Software Downloads BBS. (You must have login access to both the support site
and the BBS site in order to be able to download software)
 Verify the latest GCEMS software files (IMG_10.x.xxx and
IMGUserInterface_10.5.x.xxx) have been acquired. The files are located on the
software discs supplied or can be downloaded after logging in to the Dialogic
Technical Support Website. http://www.dialogic.com/support and selecting
Software Downloads
Linux Services Needed
The services such as DHCP and SNTP can either be run on the Linux Server that the
GCEMS is loaded on or can be set up to run on a separate machine. For ease of
configuration, Dialogic the services should run from the same machine. The services
below are installed on the GCEMS server when Linux Red Hat Enterprise is installed.
These services can be used to work with the IMG 1004
DHCP (Dynamic Host Configuration Protocol)

Required to perform BootP function for the IMG 1004. The BootP server and
the IMG 1004's must be on the same subnet.
FTP Server (Daemon)

Required to download the system software to the IMG 1004.
SNTP (Simple Network Time Protocol) Server

Required to synchronize the time on the IMG 1004. Must co-locate with the FTP
server.
NFS (Network File System)

Used to download packaged treatments to the IMG 1004.
VNC

Used for remote monitoring and configuration. Installing the VNC application is
beneficial because Dialogic Technical Support Personnel will use this application
to diagnose any issues that may arise.
Miscellaneous Information
NOTE: If you purchased your server through Dialogic or IMG 1004 supplier the
software should already be installed along with all services. If this is the case then
setting IP addresses and retrieving the latest version of software is needed and most
steps below can be avoided. If software is already installed proceed to
Downloading System
the customer will provide its own server then follow instructions below.
108
Software. If GCEMS server was purchased without software or
IMG 1004-