Dialogic IMG 1004 Installation And Setup Manual page 103

License Validation Failure
If for some reason the license isn't valid for your IMG 1004 the icon shown below will appear
in the ClientView tree after creating a Physical Node.
A license validation has failed. Verify you have the required license and that
it is configured on the IMG. See Downloading a New License and the License
Info pane.
Licensed Components
Below are the licenses that can be created for the IMG 1004. Information on each is provided.
Table 1 below shows the increments that each license can be purchased
NOTE:
If licensing remote CIC's, each remote node must have an SS7_ISUP port license that equals
the number of CIC's you want to configure on that remote node.
System Software
System Software License is needed on all IMG's and is specific to the software build
(10.5.x, 10.3.x) A basic System Software License includes as a default 1024 DSP
Resources
Swithkit _Node
®
The Switchkit
®
TDM_Port
There are a total of 128 TDM ports on the IMG 1004. (4 E1 and 4 T1) Table 1 below
displays the increments that the licenses are created.
SS7_Base
The SS7 base license will need to be loaded if SS7 is going to be used.
SS7_ISUP (CICS)
Up to 128 Ports can be licensed on the IMG 1004. See Table 1 Below.
SS7_LINK
Up to 4 links can be licensed.
CAS
Up to 128 ports can be licensed for CAS channels. By default when ordering TDM port
licenses you are automatically given the same number of CAS licenses with no extra
charge. See Table 1 below
VoIP_Ports
There are a total of 128 VoIP Ports. See Table 1 below.
ISDN_Ports
Up to 128 ports can be licensed for ISDN B/D channels. See Table 1 below.
Node license will allow GCEMS to communicate with the IMG 1004
IMG 1004 - Introduction
95