Dialogic IMG 1004 Installation And Setup Manual page 62

Installation and Setup
Create the ntp.conf file.
1. As a Super User Create the ntp.conf file. Go to
/opt/cantata/common/osconfig (Software 10.3.x to 10.5.0)
or
/opt/dialogic/common/osconfig (Software 10.5.1 +)
2. Run the ntp configuration script:
#./xlntp
3. Enter IP Address and Subnet mask when prompted as appropriate for your
configuration.
4. Move the ntp file to the /etc directory. (mv ntp.conf /etc). See Sample
ntp.conf File.
Start the services nfs, vsftpd, dhcpd, and ntp
1. As a Super User, start all the services and configure them to restart when
GCEMS server is rebooted. Enter the following commands to start the nfs server
#/sbin/service nfs start
#/sbin/service nfs status (Verify whether nfs is running or not)
#/sbin/chkconfig nfs on
GCEMS)
#/sbin/chkconfig nfs --list (Verify that runlevels 3,4 and 5 are all on.)
Example: nfs
2. Enter the following commands to start vsftpd service
#/sbin/service vsftpd start
#/sbin/service vsftpd status (Verify whether vsftpd is running or not)
#/sbin/chkconfig vsftpd on
of GCEMS)
#/sbin/chkconfig vsftpd --list (Verify that runlevels 3,4, and 5 are all on.)
3. Enter the following commands to start dhcpd service
#/sbin/service dhcpd start
#/sbin/service dhcpd status (Verify whether dhcpd is running or not)
#/sbin/chkconfig dhcpd on
of GCEMS)
#/sbin/chkconfig dhcpd --list (Verify that runlevels 3,4, and 5 are all on.)
4. Enter the following commands to start ntp service
#/sbin/service ntp start
#/sbin/service ntp status (Verify whether ntp is running or not)
#/sbin/chkconfig ntp on
GCEMS)
#/sbin/chkconfig ntp --list (Verify that runlevels 3,4, and 5 are all on.)
5. Once these services are running and the IMG software build is available the
software can be downloaded. See
54
(Start the nfs service)
(Configure nfs service to restart after a reboot of
0:off 1:off 2:on
(Start the vsftpd service)
(Configure vsftpd service to restart after a reboot
(Start the dhcpd service)
(Configure dhcpd service to restart after a reboot
(Start the ntp service)
(Configure ntp service to restart after a reboot of
IMG 1010-Downloading System Software
3:on 4:on 5:on 6:off