Dialogic IMG 1004 Quick Start Manual
Integrated media gateway
Hide thumbs
Also See for IMG 1004:
- Installation and setup manual (169 pages) ,
- Quick start manual (10 pages) ,
- Quick start manual (10 pages)
Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Quick Start Manual
Advertisement
Table of Contents
Related Manuals for Dialogic IMG 1004
Summary of Contents for Dialogic IMG 1004
- Page 1 Dialogic IMG 1004 ® Integrated Media Gateway Quick Start Guide Release 10.3.x / 10.5.x Dialogic Corporation www.dialogic.com Part # 07-8724-00 Page 1 of 7...
- Page 2 9800 Cavendish Blvd., 5th Floor, Montreal, Quebec, Canada H4M 2V9. Any authorized use of Dialogic's trademarks will be subject to full respect of the trademark guidelines published by Dialogic from time to time and any use of Dialogic’s trademarks requires proper acknowledgement.
-
Page 3: Hardware Limited Warranty
Dialogic's prior written approval or by causes beyond the control of Dialogic, including, but not limited to, power or air conditioning failure, acts of God, improper interface with other units, or malfunction of any equipment or software used with the Dialogic product(s). If Dialogic is requested and agrees to make repairs or replacements necessitated by any such causes, you will pay for such service or replacement at Dialogic's then prevailing rates. -
Page 4: Connecting Ac Power
Power Specifications The AC input power must conform to the specifications in the table below. Insert one end of AC cord into rear of IMG 1004 and the other end into a grounded wall outlet, uninterruptible power supply (UPS), or surge protector. - Page 5 GCEMS server to download system software and start configuring the IMG 1004 using the ClientView GUI. On the rear of the IMG 1004 are the network interfaces. The first interface -CTRL- is a Fast Ethernet port which is dedicated to network management and VoIP signaling.
-
Page 6: Connecting Data0 Port
Connecting DATA0 Port 1. The port DATA that is located on the rear of the IMG 1004 is a Fast-Ethernet port and is dedicated to VoIP Bearer traffic as well as signaling. The DATA port can be on the same IP network as the management network or can be connected to a separate network. -
Page 7: Starting Clientview To Start Configuring Switch
Once the IMG 1004 has software installed, the cabling is connected, and the GCEMS server has been configured then the ClientView application can be used to configure the IMG 1004. Below are a few topics from Online documentation to get you started on configuring the IMG 1004 through the ClientView GUI ...
Need help?
Do you have a question about the IMG 1004 and is the answer not in the manual?
Questions and answers