Dialogic IMG 1004 Installation And Setup Manual page 168

Installation and Setup
3. If someone has FTP'd to the IMG 1004 the "FTP Connection Status" field
and the "Remote IP Address" field will update. See screen capture
below. Notice the Remote IP address field. This is the IP address of the
PC that the user is FTP'ing from.
4. At this point, files can be FTP'd to and from the IMG 1004. Below is an
example of using FTP to change the version of software loaded on the
SD card
Procedure:
1. The following procedure will explain how to change the load on an SD Card
and upgrade the IMG 1004 software. The procedure will assume that:


NOTE: FTP Applications such as WinSCP that use SFTP (Secure FTP)
or SCP (Secure Copy) will not connect to the IMG 1004. Only the FTP
Protocol is supported for transferring the files to the IMG 1004 SD
Card.
2. Once logged in, you can transfer the new updated IMG 1004 software file.
Transfer this file as binary.
3. Verify the software file was successfully transferred by using the dir or ls
command.
3. Transfer the bootup.cfg file from the IMG 1004 with the SD Card to the PC.
160
SD Card was previously used to load IMG 1004 software and
the IMG 1004 is running with that software.
The FTP Server is configured and enabled in ClientView. See
Steps 1-4 above
From a DOS or UNIX prompt
ftp <IP address of IMG1004>
User: excelsw
Password: excelsw
ftp>
ftp> dir (dir command will show what is loaded on SD Card)
ftp> bin (Set mode to transfer file as binary)
ftp> hash (enable hash printing)
ftp> put img1004_<software version>_id0106.bin
(Transfer times could vary from 2 to 10 minutes depending
on server speed, memory size, etc.)
ftp> dir
ftp> dir (dir command will show what is loaded on SD Card)
ftp> ascii (Set mode to transfer file as ascii)
ftp> get bootup.cfg (Get copy of bootup.cfg from SD Card)