Dialogic IMG 2020 Quick Start Installation Manual

®
Dialogic
This document provides a high-
for the 2020 IMG. For detailed
documentation at
http://www.dia
Before you begin, review the pa
are any discrepancies, contact y
Locating the Base MAC
The base MAC address is printe
the 2020 IMG. The base MAC a
addresses are under software c
Use this base MAC address whe
recommend that you obtain the
identification label is similar to

Connecting AC Power

AC power modules must be plu
external grounding points on th
grounding points are for DC sys
AC input power:
100 - 240 V AC, 60 - 50
•
115 V AC @ 2 A, or 230
•
Redundant, hot-swappable AC
Note: When connecting a seco
primary AC power module.

Connecting DC Power

You must connect the DC 2020
ground to the DC 2020 IMG, us
for earth ground). Dialogic supp
attached to the grounding screw
Caution: Do not daisy-chain tw
other equipment or to a commo
DC input power:
-40 to -60 V DC (-48 V D
•
Redundant, hot-swappable DC
Warning! You must connect
signaling integrity and to pr
IMG 20 020 Integrated Multimedia Ga
Quic ck Start Installation Guide
-level overview of how to connect power and n
information about installation and setup, refe
alogic.com/manuals.
acking list to verify that you received all items
your Dialogic representative.
Address
ed on the identification label located on the un
ddress is assigned to the CTRL ports. The oth
control.
en configuring the IP address. Because of its l
e base MAC address before you install the syst
this example:
gged into three-prong grounded outlets. Do n
he rear of an AC 2020 IMG to ground the syste
stem grounding only.
0 Hz, 2 A - 1 A
V AC @ 1 A
power modules are located at the rear of the
nd power supply, you do not need to turn off
IMG to earth ground before connecting powe
se 10, 12, or 14 AWG machine tool wire (MTW
plies a two-hole #10 solderless crimp groundi
ws on the rear of the 2020 IMG.
wo or more systems. Do not wire the 2020 IM
on bus bar.
DC nominal) @ 6 A
power modules are located at the rear of the
the 2020 IMG to a true earth ground to m
revent electrical shock. Do not connect gr
1
ateway
network cabling
r to the online
s listed. If there
nderside rear of
er MAC
ocation, we
tem. The
not use the
em. These
docking station.
power to the
er. To connect a
W) (green/yellow
ng lug that is
G directly to
docking station.
maintain
round to -48 V.