Dialogic IMG 1010 Quick Start Manual
Integrated
Hide thumbs
Also See for IMG 1010:
- Quick start manual (18 pages) ,
- Installation instructions manual (9 pages) ,
- Installation and setup manual (169 pages)
Related Manuals for Dialogic IMG 1010
Summary of Contents for Dialogic IMG 1010
- Page 1 Dialogic IMG 1010 ® Integrated Media Gateway Quick Start Guide Release 10.3.x / 10.5.x Dialogic Corporation www.dialogic.com Part # 07-8728-03 Page 1 of 9...
-
Page 2: Copyright And Legal Notice
9800 Cavendish Blvd., 5th Floor, Montreal, Quebec, Canada H4M 2V9. Any authorized use of Dialogic's trademarks will be subject to full respect of the trademark guidelines published by Dialogic from time to time and any use of Dialogic’s trademarks requires proper acknowledgement. -
Page 3: Hardware Limited Warranty
Dialogic's prior written approval or by causes beyond the control of Dialogic, including, but not limited to, power or air conditioning failure, acts of God, improper interface with other units, or malfunction of any equipment or software used with the Dialogic product(s). If Dialogic is requested and agrees to make repairs or replacements necessitated by any such causes, you will pay for such service or replacement at Dialogic's then prevailing rates. -
Page 4: Connecting Ac Power
Connecting AC Power Power Specifications If the IMG 1010 is powered by AC voltage then the AC input power must conform to the specifications in the table below. Insert one end of AC cord into rear of IMG 1010 and the other end into a grounded wall outlet, uninterruptible power supply (UPS), or surge protector. -
Page 5: Connecting Dc Power
Do not wire chassis directly to other equipment or a common bus bar. The DC power module must be wired directly to a -48 fused power source. Power Specifications: If the IMG 1010 is powered by DC voltage then the DC input power must conform to the specifications in the table below. Operating Range Power -48 VDC Nominal / 1.5 - 3.0Amps... -
Page 6: Grounding Img1010 (Dc Version Only)
IMG 1010 Quick Start Guide Grounding IMG1010 (DC Version Only) The DC version of the IMG 1010 should be connected to a true earth ground. To connect chassis to ground you will need the following equipment: 14-16 AWG machine tool wire (MTW) (green/yellow) ... -
Page 7: Connecting And Configuring Network Management Port 'Ctrl 0'
2. Once the cables are connected, configure FTP and DHCP on the GCEMS server. Locate the MAC address that is printed on a label located on the underside rear of the IMG 1010. This will be used in the dhcpd.conf file creation. -
Page 8: Connecting Data0 Port
Connecting DATA0 Port 1. The port DATA 0 that is located on the rear of the IMG 1010 is a Gigabit-Ethernet port and is dedicated to VoIP Bearer traffic. The DATA 0 port can be on the same IP network as the management network, or can be connected to a separate network. -
Page 9: Connecting Tdm Signaling And Bearer Ports
Configuration > Node Configuration Wizard Configuration > Basic Configuration From here you are ready to configure the IMG 1010 for your network. Use the Online Manual Configuration, Clientview, and ClientView Pane sections to configure the IMG 1010. Dialogic Corporation...
Need help?
Do you have a question about the IMG 1010 and is the answer not in the manual?
Questions and answers