Dialogic IMG 1010 Installation Instructions Manual
  1. Manuals
  2. Brands
  3. Dialogic Manuals
  4. Gateway
  5. IMG 1010
  6. Installation instructions manual

Dialogic IMG 1010 Installation Instructions Manual

Voip module removal integrated media gateway
Hide thumbs Also See for IMG 1010:
1
2
3
4
5
6
7
8
9
Table of Contents

Advertisement

Quick Links

Download this manual
®
Dialogic
IMG 1010 Integrated Media Gateway
IMG 1010 VoIP Module Removal/Installation Instructions
April 2009
www.dialogic.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the IMG 1010 and is the answer not in the manual?

Questions and answers

Related Manuals for Dialogic IMG 1010

Summary of Contents for Dialogic IMG 1010

  • Page 1 ® Dialogic IMG 1010 Integrated Media Gateway IMG 1010 VoIP Module Removal/Installation Instructions April 2009 www.dialogic.com...

  • Page 2: Copyright And Legal Notice

    9800 Cavendish Blvd., 5th Floor, Montreal, Quebec, Canada H4M 2V9. Any authorized use of Dialogic's trademarks will be subject to full respect of the trademark guidelines published by Dialogic from time to time and any use of Dialogic’s trademarks requires proper acknowledgement.

  • Page 3: Hardware Limited Warranty

    Additional Exclusions: Dialogic will have no obligation to make repairs or replacements to the Product due to causes beyond the control of Dialogic, including, but not limited to, power or air conditioning failure, acts of God, improper interface with other units, or malfunction of any equipment or software used with the Dialogic Product(s).

  • Page 4: Warranty Information

    Overview: ® The procedures below pertain to the removal and installation of the Dialogic IMG 1010 VoIP Module ® which is located on the Dialogic IMG 1010 Motherboard. We recommend that removal and installation be performed only by qualified technical personnel who are familiar with this procedure.
  • Page 5 Place your index fingers and thumbs under opposite corners and repeat such that you lift a little bit more each time. Continue this process until the module is freed from the connectors. Figure 1 Dialogic Corporation Part # 07-8740-02 Page 5 of 9...
  • Page 6 Reconnect power and cabling. Switch the power to ON (1) at rear of docking station and allow software to load. To configure the module, start GCEMS and ClientView. See the Dialogic Manuals website located at http://www.dialogic.com/manuals for information on starting GCEMS and ClientView...

  • Page 7: Configuring A 1010 Voip Module

    Logical Interface - If VoIP Module 0 or 1 is selected the Logical Interface will default to Redundant Data. The VoIP Modules use the Data ports on the rear of the IMG 1010 for IP Communications.

  • Page 8: Configure 1010 Voip Module Resources

    Fully Qualified Domain Name - The FQDN will be inserted in outgoing SIP messages when FDQN is enabled in the SIP Profile. See Fully Qualified Domain Name Support for more information. Dialogic Corporation Part # 07-8740-02 Page 8 of 9...
  • Page 9 Click on the Object Table tab at bottom of ClientView. Modules should show “In Service Idle”. See below. 5. For more information on the 1010 VOIP Module please see the VoIP Module pane reference in the IMG WebHelp located at https://www.dialogic.com/manuals. Dialogic Corporation Part # 07-8740-02...

Table of Contents