Yamaha M7CL Owner's Manual page 93

● Making HA settings
(input channels only)
To control the head amp (HA) assigned to an INPUT/ST
IN channel, you will use the [HA] encoder of the
SELECTED CHANNEL section and the HA field of the
SELECTED CHANNEL VIEW screen. The HA field
includes the following items.
5
1
1 GAIN knob
This indicates the gain of the head amp assigned to the
channel. To adjust the value, use the [HA] encoder of
the SELECTED CHANNEL section.
B INPUT PORT popup button
This shows the input port assigned to this channel. It
also accesses a popup window in which you can select
the input port.
C +48V
This indicates the phantom power on (red) or off
(black) status for the head amp assigned to the chan-
nel.
D ø (Phase)
This indicates either normal phase (black) or reverse
phase (orange) for the input assigned to the channel.
E OVER indicator
This will light when the input signal from the HA
reaches the overload point.
To adjust the head amp gain, use the [HA] encoder of the
SELECTED CHANNEL section.
When you press the GAIN knob in the screen, the HA/
PATCH popup window (1 ch) will appear, allowing you to
make settings for the head amp. (For details on the popup
window → p. 61). When you press the INPUT PORT but-
ton, the PATCH/NAME popup window will appear, allow-
ing you to select the input port for each channel. (For
details on the popup window → p. 108).
NOTE
• The PAD will be internally switched on or off when the HA gain is
adjusted between -14 dB and -13 dB. Keep in mind that noise may
be generated if there is a difference between the Hot and Cold
output impedance of the external device connected to the INPUT
connector when using phantom power.
2
3 4
Operations in the SELECTED CHANNEL section
● Setting the pan/balance
To adjust the pan/balance of the signal sent from that
channel to the STEREO bus, use the [PAN] encoder of the
SELECTED CHANNEL section and the TO ST PAN/
BALANCE field of the SELECTED CHANNEL VIEW
screen. The TO ST PAN/BALANCE field includes the fol-
lowing items.
1
1 PAN/BALANCE knob
The following parameter will change, according to the
channel that is selected.
INPUT channel
ST IN channel
MIX (MONO×2) channel
MIX (STEREO) channel
MATRIX (MONO×2) channel
MATRIX (STEREO) channel
STEREO channel
MONO channel
B ST/MONO button
(INPUT, ST IN, and MIX channels only)
This switches the on/off status of the signal sent from
that channel to the STEREO (L/R) bus and MONO
(C) bus.
C LCR button
(INPUT, ST IN, MIX channels only)
If an INPUT, ST IN, or MIX channel is set to LCR
mode, the LCR button is displayed in location (
The LCR button is an overall on/off switch for the sig-
nals sent from the channel to the STEREO bus and
MONO bus.
To adjust the pan/balance of each channel, use the ST/
MONO button or LCR button to select the send-destina-
tion bus, and operate the [PAN] encoder of the
SELECTED CHANNEL section.
2
TO STEREO PAN
TO STEREO BALANCE
TO STEREO PAN
MIX BALANCE
Not displayed
MATRIX BALANCE
STEREO BALANCE
Not displayed
3
2 ).
93
M7CL Owner's Manual
7