Yamaha M7CL Owner's Manual page 44

Connecting SB168-ES units to the M7CL-48ES using the STAGE BOX SETUP function
■ Daisy chain connection
1
Connect the EtherSound [OUT] connector on the M7CL-48ES to the [IN] connector of the first
SB168-ES unit, and daisy chain subsequent units as shown in the diagram.
OUT
M7CL-48ES
2
Set the dip switches on the SB168-ES units as shown in the table below.
Number of SB168-ES units
Three
Two
One
3
Turn on the power to the M7CL-48ES and the SB168-ES units. If M7CL-48ES's scene #000 is not
selected, recall scene #000. p. 138
After the steps above are completed, patches are assigned as follows:
SB168-ES
INPUT 1–16 jacks
ID #1 OUTPUT 1–6 jacks
OUTPUT 7/8 jacks
INPUT 1–16 jacks
ID #2 OUTPUT 1–6 jacks
OUTPUT 7/8 jacks
INPUT 1–16 jacks
ID #3 OUTPUT 1–6 jacks
OUTPUT 7/8 jacks
NOTE
• To change the input or output channel patches on the M7CL-48ES, access M7CL-48ES's PATCH/NAME popup window.
• If you want to change the EtherSound patches from AVS-ESMonitor, refer to "Changing the EtherSound settings from
AVS-ESMonitor (M7CL-48ES)" ( → p. 243).
• The word clock setting cannot be changed if the AUTO CONFIGURE button is turned ON.
• For more information on the AUTO CONFIGURE button, please refer to "Connecting SB168-ES units to the M7CL-48ES
using the Stage Box Setup function" ( → p. 242).
44
M7CL Owner's Manual
EtherSound
IN
SB168-ES (ID #1)
ID #1
1&7 2&7
1&7 2&8
1&8
EtherSound patches set via
the Auto Configure
ES IN 1–16
ES OUT 1–6
ES OUT 7/8
ES IN 17–32
ES OUT 9–14
ES OUT 15/16
ES IN 33–48
ES OUT 17–22
ES OUT 23/24
OUT IN OUT
SB168-ES (ID #2)
ID #2 ID #3
3&8
—
M7CL-48ES patches set via
scene 000
CH 1–16
MIX 1–6
STEREO L/R
CH 17–32
MIX 7–12
STEREO L/R
CH 33–48
MATRIX 1–6
STEREO L/R
IN
SB168-ES (ID #3)
—
—