Yamaha M7CL Owner's Manual page 182

About the internal effects
6
To adjust the effect send level of an input
channel, use the navigation keys to access
the OVERVIEW screen that includes the
input channel you want to control.
2
1
1 TO MIX/TO MATRIX field
B TO MIX SEND LEVEL knob
7
Make sure that a MIX bus is selected as the
send-destination of the TO MIX/TO MATRIX
field.
If a MATRIX bus is selected as the send-destination
(the field indicates "TO MATRIX"), use the
SELECTED CHANNEL VIEW screen's TO MIX/TO
MATRIX button to switch to a MIX bus (→ p. 175).
8
Press the TO MIX SEND LEVEL knob that
corresponds to the desired MIX bus, and
turn the multifunction encoder to adjust the
send level of the signal sent from each
channel to the MIX bus.
In this state you can adjust the send level of the signal
sent from the input channel to the internal effect.
Adjust the send level of other input channels in the
same way.
If you press the selected knob once again, the MIX
SEND popup window (8 ch) for the send-destination
MIX bus will appear. This popup window contains on/
off switches for the signals sent from each channel to
the corresponding bus, and lets you select the send
point (PRE or POST) (→ p. 70).
NOTE
• At this time, you must be sure that the send level from the ST
IN channel you selected in step 3 to the corresponding MIX
bus is set to 0. If you raise this send level, the output of the
effect will be returned to the input of the same effect, possibly
causing oscillation.
182
M7CL Owner's Manual
9
To adjust the master level of the effect
send, call up the MIX channel you specified
as the input-source of the rack in step 2 to
the Centralogic section, and adjust the cor-
responding fader.
Set the level as high as possible without allowing the
post-effect signal to reach the overload point.
HINT
• The input/output levels of the effect are shown by the input/
output meters at the upper right of the EFFECT popup win-
dow.
10
To adjust the effect return level, operate the
ST IN channel you selected as the output-
destination for the rack in step 3.