Yamaha M7CL Owner's Manual page 76

Sending the signal from an input channel to the MATRIX buses
4
Use the MATRIX bus selection buttons in
the function access area to select the send-
destination MATRIX bus.
Alternatively, press a SEND LEVEL knob in the
SELECTED CHANNEL section to display a popup
window, from which you can select a MATRIX bus.
HINT
• Alternatively, press a SEND LEVEL knob in the SELECTED
CHANNEL section to display a popup window, from which you
can select a MIX bus.
• You can also select a MATRIX bus by using the navigation
keys and the [SEL] keys in the Centralogic section. If the MIX
buses or MATRIX buses are selected when you press the
[SEL] keys, the setting of the MIX/MTRX ON FADER switch
button will be changed automatically.
• If you press the currently-selected MATRIX bus select button,
cue monitoring will be turned on for the related MATRIX chan-
nel. This method is convenient if you want to monitor the sig-
nal that is being sent to the selected MATRIX bus.
5
Use the faders in the INPUT or ST IN sec-
tion on the top panel to adjust the send
level of the signals routed from the input
channels to the selected MATRIX bus.
HINT
• You can assign the SENDS ON FADER function to a user-
defined key. This lets you quickly switch to SENDS ON
FADER mode for a specific MATRIX bus, and quickly switch
back again.
76
M7CL Owner's Manual
6
Repeat steps 4–5 to adjust the send level
for other MATRIX buses in the same way.
7
When you're finished adjusting the MATRIX
send levels, press the "
function access area.
The function access area display will return to its prior
state, and the M7CL will exit SENDS ON FADER
mode and return to normal mode.
×
" symbol in the