Yamaha M7CL Owner's Manual page 45

■ Ring connection
1
Connect the EtherSound [OUT] connector on the M7CL-48ES to the [IN] connector of the first
SB168-ES unit, daisy chain subsequent units, then connect the [OUT] connector of the last
SB168-ES unit to the [IN] connector on the M7CL-48ES as shown in the diagram to complete a
ring connection.
IN OUT
M7CL-48ES
2
Set the dip switches on the SB168-ES units as shown in the table below.
Number of SB168-ES units
Three
Two
One
3
Turn on the power to the M7CL-48ES and the SB168-ES units.
4
In the function access area on the right part of the screen, press the RACK button (1) to access
the VIRTUAL RACK window.
5
Press the EXT-ES HA tab (2) to display the EXT-ES HA field.
6
Press the AUTO CONFIGURE button below the EXT-ES HA field.
The AUTO CONFIGURE button is set to off and its indicator turns off.
7
Press the RING button to the right of the AUTO CONFIGURE button.
The connection setting is configured for a ring connection.
8
Press the AUTO CONFIGURE button.
A dialog box confirming the change is displayed.
9
Press the OK button.
The AUTO CONFIGURE button and its indicator will turn on.
10
If M7CL-48ES's scene #000 is not selected, recall scene #000. p. 138
Connecting SB168-ES units to the M7CL-48ES using the STAGE BOX SETUP function
EtherSound
IN
SB168-ES (ID #1)
ID #1
1&5 2&5
1&5 2&6
1&6
2
OUT IN OUT
SB168-ES (ID #2)
ID #2 ID #3
3&6
—
— —
1
IN OUT
SB168-ES (ID #3)
45
M7CL Owner's Manual
4