Setting The Network Settings Using Command View Vls; Setting The User Preferences - HP 12000 User Manual

NOTE:
To reset a value, enter " " (quoted space) as the value.
NOTE:
for both the first and second DNS server addresses.
4. When all the network parameters are set to your desired values, save the settings by entering:
commitConfig
5. Verify the network settings have been changed by entering:
showConfig

Setting the Network Settings using Command View VLS

To set the network settings using Command View VLS, set either the:
DHCP usage and host name, or
Fully qualified host name (or host name and DNS domain name separately), DNS server
address, IP address, gateway, and netmask
To set the network settings using Command View VLS:
1. Click the System tab.
2. Select Chassis in the navigation tree.
3. Select Set Network Configuration under Maintenance Tasks.
4. Current network configuration, NTP settings, and time zone settings are displayed. Modify
these as needed
Figure 13 Set Network Configuration Wizard window
5. Click Finish to apply the settings.
NOTE:
NOTE:
0.0.0.0 for both the primary and secondary DNS server addresses.

Setting the User Preferences

Setting the user preferences allows you to:
86 Configuration
More than one network value can be set at a time or you can set them individually.
If you need to clear the DNS completely, set the DHCP to false and enter 0.0.0.0
(Figure 13 (page
The system automatically reboots after any change.
If you need to clear the DNS completely, clear the Use DHCP checkbox and enter
86)).