Configuration Commands - HP 12000 User Manual

Table 16 CLI Network Settings Configuration Commands (continued)
Command
getDateTime
setDateTime
commitConfig
NOTE: To reset a value to its default setting, set the option tag to " " (quoted space). For example:
fullhost=" "
The exception to this is the dhcp tag. DHCP is disabled by entering:
-dhcp=false
Any network configuration changes made using setConfigValue do not take effect until
"committed", using the commitConfig command.

Configuration Commands

Use the CLI commands in
Edit the Fibre Channel host port settings
Enable oversubscription and view oversubscription settings
View LUN mapping
Create, view, and destroy virtual libraries, tape drives, or cartridges
Add, view, or remove barcode templates
Table 17 CLI Configuration Commands
Command
addNode
discoverArray
updateFC
Description
-dnsaddr2 - Second DNS server address (cannot use with dnsaddr)
-dhcp - Has no value, indicates you want to configure the public Ethernet connection
using DHCP (reset is -dhcp=false)
-ipaddr - IP address of public Ethernet connection
-gate - Gateway to network (xx.xx.xx.x)
-mask - Netmask. Defaults to 255.255.255.0
Displays the day, date, time, time zone, and year (such as Mon March 14 1 1:30:46
EST 2005).
Sets the date and time. Where the options are:
-d < s > - Date and time in yyyy-mm-dd hh:mm format (hh is 24 hour from 0) (required).
Example: setDateTime -d "2009-06-09 09:45:00"
-h - Displays command usage information (optional)
Saves the system values changed using setConfigValue.
CLI configuration commands
1
Usage
Add a node to the VLS. See getNodeNames.
Discovers any new arrays added to the VLS.
Changes the default FC host port connection settings. Where the options are:
-a <n> - ID number of node to modify (0, ...) (optional)
-i <n> - FC index (0, 1, ...) (required)
-l <n> - If attached in arbitrated loop mode, specifies a hard ALPA value between 0
and 125. A value of - 1 specifies a dynamically assigned ALPA. If not attached to an
arbitrated loop, this parameter is ignored (required)
-r <n> - Port number of the FC port to modify (required)
-s <n> - Preferred speed (0-Auto, 1-One GB, 2-Two GB, 4-Four GB, or 10-Ten GB)
(required)
-t <n> - Preferred topology (0-Auto, 1-Point to Point, 2-Loop, 3-Fabric, or 4-Public Loop)
(required)
to:
VLS Commands 137