Power Supply - HP 12000 User Manual
Hp 12200 gateway virtual library system user guide (bw403-10001, june 2011)
Hide thumbs
Also See for 12000:
- User manual (266 pages) ,
- Manual (218 pages) ,
- Design manual (160 pages)
Table of Contents
Advertisement
Power Supply
CAUTION:
all bays are populated with either a component or a blank.
1.
Disconnect the power cord from the power supply.
2.
Press the power supply release lever (1), and then pull the power supply from the node.
To replace the component:
WARNING!
the power cord to the power supply until the power supply is installed.
1.
Remove the protective cover from the connector pins on the power supply.
2.
Slide the power supply into the bay until it clicks.
3.
Use the strain relief clip to secure the power cord.
4.
Connect the power cord to the power supply.
To prevent improper cooling and thermal damage, do not operate the node unless
To reduce the risk of electric shock or damage to the equipment, do not connect
VLS Node Component Replacement 159
Advertisement
Table of Contents
