Table of Contents
Advertisement
✏
NOTE
The above procedures install only the controller drivers. To install the StorCon NLM, follow the
procedure under Add Intel RAID Controller(s), drivers, and/or StorCon to and existing NetWare
installation and select Storage RAID Controller Tools Kit (STORCON.NLM) option.
Adding Intel RAID SRCU31 Controller(s), Drivers, and/or
StorCon to an Existing NetWare Installation
Install all Novell patches and updates prior to installing the Intel RAID Controller SRCU31 driver
and StorCon. These updates can be found at:
http://www.novell.com
1. Create a driver diskette from the RAID Software Suite CD-ROM. See Chapter 2 for details to
create this disk.
2. Power off the system and add the Intel RAID Controller SRCU31 card(s).
3. Power on the system and boot to the OS.
4. Load INSTALL.NLM (For 4.2 only).
5. Load NWCONFIG.NLM (For 5.x and above).
6. Insert the driver diskette into drive A:
7. Do one or both of the following to install the desired packages (you do not need to reinstall the
driver package if you initially installed the driver using one of the steps under New Installation
of NetWare 4.2 and 5.1).
Installing the Intel RAID Controller SRCU31 Driver Package
1. Select "Product options," then "Install a product not listed."
2. Change the path to A:\INSTALL and press <Enter> to continue.
3. Select "Storage RAID Controller Driver" (SRCRX.HAM) by setting the cursor on its menu
item and pressing the space bar (an X will appear in the item's checkbox).
4. Press <F10> to accept the selected item.
5. After the file copy is complete, select "Return to previous menu" to get back to the
INSTALL/NWCONFIG main options.
6. Select "Driver Options."
7. Select "Configure disk and storage device drivers."
8. Select "Discover and load additional drivers."
9. Press <Enter> to continue past any module load errors not related to the Intel RAID
Controller SRCU31.
Installing Novell Netware
65
Advertisement
Table of Contents
