Table of Contents
Advertisement
4. Complete the text-based portion of the Windows installation procedures. Reboot and continue
with the GUI-based portion of the installation.
5. After the operating system is completely installed, go to Chapter 7, Loading StorCon to
complete the installation.
Installing Windows Using the Bootable Windows CD-ROM:
1. Press <F6> as soon as the initial blue screen appears to ensure that the RAID Driver Installation
diskette can be loaded when specifying "Other."
2. When device detection is complete, press <S> to specify additional storage devices.
3. Select "Other." Insert the Intel RAID Controller SRCU31 Installation diskette for Windows
into the floppy drive. Press <Enter>.
4. Intel RAID Controller SRCU31 is automatically selected. Press <Enter>.
5. Complete the text-based portion of the Windows installation procedures. Reboot and continue
with the GUI-based portion of the installation.
6. After the operating system is completely installed, go to Chapter 7, Loading StorCon to
complete the installation.
Installing an OS onto an IDE or SCSI Hard Disk Drive Not Attached to the Intel
RAID Controller SRCU31
Install the Intel RAID Controller SRCU31:
1. Power-off the computer.
2. Disconnect all power cords.
3. Remove the computer case to expose the server board inside. Observe all warnings and
cautions documented with the computer system to avoid shock hazards.
4. Install the Intel RAID Controller SRCU31 into an available PCI slot.
5. Replace the computer case and reconnect power cords.
6. Go to the next section for the operating system to continue the installation.
Windows 2000 / NT 4.0 Installation Procedures
✏
NOTE
This document, when referring to Windows 2000 and Windows NT, applies to the following
Windows operating systems:
•
Windows 2000 Server, Advanced Server, and Professional
•
Windows NT 4.0 Server, Enterprise Edition, Terminal Server Edition, and Workstation
50
Intel RAID SRCU31 Users Guide
Advertisement
Table of Contents
Need help?
Do you have a question about the SRCU31A - Server RAID U3-1A Controller and is the answer not in the manual?