Table of Contents
Advertisement
Configuring AppleTalk
Configuring AppleTalk
Configure AppleTalk to enable Macintosh clients to access network resources by dialing through the
access server over ISDN.
Configure
Table 3-28
Step Command
1
2
3
4
1. ATCP = AppleTalk Control Protocol.
2. ARAP = AppleTalk Remote Access Protocol.
Verify
To verify the AppleTalk interface is up and running:
•
3-52
Cisco AS5300 Universal Access Server Software Configuration Guide
Accessing AppleTalk Networks
5300# configure terminal
Enter configuration commands, one per line.
End with CNTL/Z.
5300(config)#
5300(config)# appletalk routing
5300(config)# appletalk virtual-net 2 ATCP
Zone
5300(config)# appletalk cable-range 1-1
1.120
5300(config-if)# appletalk zone Ethernet
5300(config-if)# exit
5300(config)# exit
5300# copy running-config startup-config
#########[OK]
Enter the show appletalk interface serial command:
5300# show appletalk interface serial 1:23
Serial1:23 is up, line protocol is up
AppleTalk address is 10.1, Valid
AppleTalk zone is "dolzone"
AppleTalk discarded 37 packets due to output errors
AppleTalk address gleaning is not supported by hardware
AppleTalk route cache is disabled, Dial on Demand specified
Purpose
Enter global configuration mode. You have
entered global configuration mode when the
prompt changes to
5300(config)#.
Enable AppleTalk routing and set the AppleTalk
1
zone ATCP
on network 2 (your network number
and zones may differ).
All users that dial in to the system will belong to
the AppleTalk network 2 in the AppleTalk zone
ATCP Zone. All the dial-in users will look as
though they are on a single network. Links will
not have their own network numbers. This
applies to configurations using PPP instead of
2
ARAP
encapsulation.
Set the AppleTalk cable range and the AppleTalk
zone on the Ethernet interface.
Completes configuration for AppleTalk
operation. Save the running configuration to the
startup configuration.
Advertisement
Table of Contents
