Table of Contents
Advertisement
Modem Callout, Modem RI is CD, Line usable as async interface
Modem state: Idle
Special Chars: Escape
^^x
Timeouts:
Idle EXEC
00:10:00
Modem type is unknown.
Session limit is not set.
Time since activation: never
Editing is enabled.
History is enabled, history size is 10.
DNS resolution in show commands is enabled
Full user help is disabled
Allowed transports are pad telnet rlogin.
No output characters are padded
No special data dispatching characters
modem(slot/port)=1/0, csm_state(0x00000100)=CSM_IDLE_STATE, bchan_num=-1
modem_status(0x0000): VDEV_STATUS_UNLOCKED
Modem hardware state: CTS noDSR
Tips
If you are having trouble:
•
If you are having problems with making or receiving calls, make sure you turned on the protocols
for connecting to the lines (step 4 in the previous configuration table) and configured for
incoming and outgoing calls (step 6 in the previous configuration table).
•
If the calls are not coming up at all, turn on the debug modem, debug modem csm, and debug
isdn q931 commands to check for problems. When you finish viewing the messages, turn off the
messages by entering the no debug modem command.
5300# debug modem
5300# debug modem csm
5300# debug isdn q931
5300# no debug modem
5300# no debug modem csm
5300# no debug isdn q931
The following is the sample output for a MICA modem for an outgoing ISDN voice call:
5300# 1.17.30.12 2004
Trying 1.17.30.12, 2004 ... Open
TTY4: asserting DTRatdt1000
Mica Modem(2/3): Rcvd Dial String(1000)
CSM_PROC_IDLE: CSM_EVENT_MODEM_OFFHOOK at slot 2, port 3
CSM_PROC_OC3_COLLECT_ALL_DIGIT: CSM_EVENT_GET_ALL_DIGITS at slot 2, port 3
CSM_PROC_OC3_COLLECT_ALL_DIGIT: called party num: (1000) at slot 2, port 3
ISDN Se0:23: TX ->
Bearer Capability i = 0x8090A2
Channel ID i = 0xE1808397
Called Party Number i = 0xA1, '1000'
ISDN Se0:23: RX <-
Channel ID i = 0xA98397
EVENT_FROM_ISDN::dchan_idb=0x60DD2D74, call_id=0xA001, ces=0x1
bchan=0x16, event=0x3, cause=0x0
Hold
Stop
Start
none
-
-
Idle Session
never
Idle Session Disconnect Warning
never
DTR RTS
SETUP pd = 8
callref = 0x0001
CALL_PROC pd = 8
callref = 0x8001
Disconnect
Activation
none
Modem Answer
Session
none
Preferred is telnet.
Verify
Dispatch
not set
Basic Configuration 3-31
Advertisement
Table of Contents
