Verify - Cisco AS5300-96VOIP-A Software Configuration Manual

Table 3-5
Duplex Mode
full
half
full

Verify

To verify the IP address, configured and actual speed, and configured and actual duplex operations:
•
•
•
•
Tips
If you are having trouble:
•
•
Using Different Duplex and Speed Options
Speed Mode
10
100
100
Enter the show arp command to verify the IP address:
5300# show arp
Protocol Address
Internet 172.16.254.250
Enter the show interface fastethernet 0 command to verify the configured speed:
5300# show interface fastethernet 0
FastEthernet0 is up, line protocol is up
Hardware is DEC21140, address is 00e0.1e3e.c125 (bia 00e0.1e3e.c125)
Internet address is 2.2.2.2/8
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec, rely 255/255, load 2/255
Encapsulation ARPA, loopback not set, keepalive set (10 sec), auto duplex,
100BaseTX/FX, 100Mb/s
Enter the show controller fastethernet 0 command to verify actual speed or duplex if speed or
duplex are configured as auto:
5300# show controller fastethernet 0
DEC21140
Setup Frame
(0) 00e0.1e3e.c125
(1) 0100.0ccc.cccc
dec21140_ds=0x606A0078, registers=0x3C210000, ib=0x4002F75C, ring entries=128
rxring=0x4002F844, rxr shadow=0x606F5168, rx_head=47, rx_tail=47
txring=0x4003006C, txr shadow=0x606F5388, tx_head=63, tx_tail=63, tx_count=0
tx_size=128, rx_size=128
PHY link up
Duplex mode sensed by auto-negotiation is half-duplex and Fast Ethernet speed is 100
Mbps.
Enter the show interface fastethernet 0 command to verify the configured duplex operation:
5300# show interface fastethernet 0
FastEthernet0 is up, line protocol is up
Hardware is DEC21140, address is 00e0.1e3e.c125 (bia 00e0.1e3e.c125)
Internet address is 2.2.2.2/8
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec, rely 255/255, load 2/255
Encapsulation ARPA, loopback not set, keepalive set (10 sec), auto duplex,
100BaseTX/FX, auto speed
Make sure the cable connections are not loose or disconnected.
Make sure you are using the correct IP address.
Action
Sets 10 Mbps for speed and full-duplex for duplex.
Sets 100 Mbps for speed and half-duplex for duplex.
Sets 100 Mbps for speed and full-duplex for duplex.
Age (min) Hardware Addr
_ 0800.207e.bead
Type Interface
ARPA FastEthernet0
Basic Configuration 3-7
Verify