Table of Contents
Advertisement
Upgrading VoIP Feature Card Firmware
Step
7
8
9
10
After you have completed the preceding tasks, reboot the Cisco AS5300 for these changes to take
effect.
Verify
To check that you have successfully downloaded the software:
•
•
D-6
Cisco AS5300 Universal Access Server Software Configuration Guide
Command
5300# unbundle vfc slot_number
5300# show vfc slot_number directory
5300#
5300# show vfc slot_number default-list
5300#
5300# show vfc slot_number cap-list
5300#
Run the show vfc slot_number directory command to verify that the VCWare is in the Flash
memory. Only one filename should appear. If this command times out, start over with "Determine
the number of VFC cards".
5300# show vfc 1 dir
Files in slot 1 VFC flash:
File Name
1.
vcware.vcw
Run the show vfc slot_number default-list and show vfc slot_number cap-list commands to
verify that the DSPWare has been unbundled and the default-list and cap-list have been
initialized.
5300# show vfc 1 default-list
% Invalid input detected at '^' marker.
5300# show vfc 1 cap-list
Capability List for VFC in slot 1:
1. fax-vfc-l.0.13.0.bin
2. bas-vfc-l.0.13.0.bin
3. cdc-g729-l.0.13.0.bin
4. cdc-g711-l.0.13.0.bin
5300#
Size (Bytes)
291292
Purpose
Unbundle the DSPWare from the
VCWare and configure the default file
list and the capability list.
Verify that the DSPWare has been
unbundled.
Verify that the default file list has been
populated.
Verify that the capability list has been
populated.
Advertisement
Table of Contents
