Cisco AS5300-96VOIP-A Software Configuration Manual page 173

Make sure the starting and ending addresses of the IP pool are in the same subnet.
Note
Enter the starting address of IP local pool? [X.X.X.X]: 172.20.30.40
Enter the ending address of IP local pool? [X.X.X.X]: 172.20.30.88
What is the username of the test user? [user]:
What is the password of the test user? [passwd]:
Will you be using the modems for outbound dialing? [no]:
Configure for Async IPX? [yes]: no
Configure for Appletalk Remote Access (ARA)? [no]: yes
AppleTalk Network for ARAP clients [1]:
Zone name for ARAP clients [ARA Dialins]:
Allow ARAP "Guest" logins? [yes/no]: yes
Step 26 Configure the Ethernet 0 LAN interface:
Configuring interface Ethernet0:
Is this interface in use? [yes]:
Configure IP on this interface? [yes]:
IP address for this interface: 172.21.40.10
The next prompts ask about the number of bits in the host portion of the subnet mask.
Number of bits in subnet field [0]:
Class B network is 172.21.0.0, 0 subnet bits; mask is /16
Configure AppleTalk on this interface? [no]: yes
Extended AppleTalk network? [no]:
AppleTalk network number [0]: 10
AppleTalk zone name [myzone]: etherzone
Configure IPX on this interface? [no]: yes
IPX network number [1]:
Step 27 Configure the Fast Ethernet 0 interface:
Configuring interface FastEthernet0:
Is this interface in use? [yes]:
Note Full duplex mode enables simultaneous data transfer between a sending and a
receiving station.
Operate in full-duplex mode? [no]: yes
Operate at 100 Mbps speed? [yes]: yes
Configure IP on this interface? [yes]:
IP address for this interface: 172.22.50.10
The next prompts ask about the number of bits in the host portion of the subnet mask.
Number of bits in subnet field [0]:
Class B network is 172.22.0.0, 0 subnet bits; mask is /16
Configure AppleTalk on this interface? [no]: yes
Extended AppleTalk network? [no]: yes
AppleTalk starting cable range [0]:
Configure IPX on this interface? [no]: yes
IPX network number [2]:
Running Setup for Cisco IOS Release 11.3(2)T
Using Setup on Cisco IOS Releases 11.2 or 11.3(2)T C-13