Table of Contents
Advertisement
Configure
Table 3-3
Step
1
2
3
4
5
6
Verify
To verify you have assigned the correct IP address:
•
Tips
If you are having trouble:
•
•
Configuring Ethernet 100BaseT
Assign an IP address to the Ethernet 100BaseT interface of your access server so that it can be
recognized as a device on the Ethernet LAN. The Fast Ethernet interface supports 10- and 100-Mbps
speeds with the 100BaseT and 10BaseT routers, hubs, and switches.
Configuring Ethernet 10BaseT
Command
5300> enable
Password: <password>
5300#
5300# configure terminal
Enter configuration commands, one per line. End
with CNTL/Z.
5300(config)#
5300(config)# interface ethernet 0
5300(config-if)#
5300(config-if)# ip address 172.16.254.254
255.255.255.0
5300(config-if)# no shutdown
5300(config-if)# Ctrl-Z
5300#
%SYS-5-CONFIG_I: Configured from console by
console
Enter the show arp command:
5300# show arp
Protocol
Address
Internet 172.16.254.254
5300#
Make sure the cable connections are not loose or disconnected.
Make sure you are using the correct IP address.
Age (min)
Hardware Addr
_
0800.207e.bead
Purpose
Enter enable mode (also called
privileged EXEC mode).
Enter the password.
You have entered enable mode when the
prompt changes to
.
5300#
Enter global configuration mode. You
have entered the global configuration
mode when the prompt changes to
5300(config)#.
Enter Ethernet interface configuration
mode.
Assign an IP address and subnet mask to
the interface.
Without issuing this command, you will
not have a connection to the network.
Return to enable mode.
This message is normal and does not
indicate an error.
Type
Interface
ARPA
Ethernet0
Basic Configuration 3-5
Configure
Advertisement
Table of Contents
