Table of Contents
Advertisement
TN3270 Emulation software.
Primary Rate ISDN software, Version 1.0.
Backplane revision 1
Manufacture Cookie is not programmed.
1 Ethernet/IEEE 802.3 interface(s)
1 FastEthernet/IEEE 802.3 interface(s)
48 terminal line(s)
4 Channelized T1/PRI port(s)
128K bytes of non-volatile configuration memory.
8192K bytes of processor board System flash (Read/Write)
4096K bytes of processor board Boot flash (Read/Write)
Notice: NVRAM invalid, possibly due to write erase.
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
When the following message appears, press Enter to accept the default entry (yes) in
Step 3
square brackets:
Would you like to enter the initial configuration dialog? [yes]:
When the following message appears, press Enter to see the current interface summary:
Step 4
First, would you like to see the current interface summary? [yes]:
Any interface listed with OK? value "NO" does not have a valid configuration
Interface
Ethernet0
FastEthernet0
Enter a host name for the access server (this example uses 5300):
Step 5
Configuring global parameters:
Enter host name [Router]: 5300
The enable secret is a one-way cryptographic secret used
instead of the enable password when it exists.
Enter an enable secret password. This password is encrypted (more secure) and cannot be
Step 6
seen when viewing the configuration:
Enter enable secret: lab
The enable password is used when there is no enable secret
and when using older software and some boot images.
Enter an enable password that is different from the enable secret password. This password
Step 7
is not encrypted (less secure) and can be seen when viewing the configuration:
Enter enable password: guessme
Step 8
Enter the virtual terminal password, which prevents unauthenticated access to the router
through ports other than the console port:
Enter virtual terminal password: guessagain
Respond to the following prompts as appropriate for your network:
Step 9
Configure SNMP Network Management? [yes]:
Community string [public]:
IP-Address OK? Method Status
unassigned
NO
unset
unassigned
NO
unset
Using Setup on Cisco IOS Releases 11.2 or 11.3(2)T C-3
Running Setup for Cisco IOS Release 11.2
Protocol
up
up
up
down
Advertisement
Table of Contents
