Table of Contents
Advertisement
San Jose, California 95134-1706
Cisco Internetwork Operating System Software
IOS (tm) 5300 Software (C5300-JS-M), Released Version 12.0(19981001:221340)
[ayeh-wk_0_6_0 100]
Copyright (c) 1986-1998 by cisco Systems, Inc.
Compiled Thu 01-Oct-98 15:13 by ayeh
Image text-base: 0x600088E8, data-base: 0x609F6000
cisco AS5300 (R4K) processor (revision A.14) with 32768K/16384K bytes of memory.
Processor board ID 05433592
R4700 processor, Implementation 33, Revision 1.0 (512KB Level 2 Cache)
Bridging software.
X.25 software, Version 3.0.0.
SuperLAT software copyright 1990 by Meridian Technology Corp).
TN3270 Emulation software.
Primary Rate ISDN software, Version 1.1.
Backplane revision 2
Manufacture Cookie Info:
EEPROM Type 0x0001, EEPROM Version 0x01, Board ID 0x30,
Board Hardware Version 1.0, Item Number 73-2414-2,
Board Revision 3, Serial Number 05433592,
PLD/ISP Version 255.255, Invalid Date code.
1 Ethernet/IEEE 802.3 interface(s)
1 FastEthernet/IEEE 802.3 interface(s)
4 Serial network interface(s)
120 terminal line(s)
4 Channelized T1/PRI port(s)
128K bytes of non-volatile configuration memory.
8192K bytes of processor board System flash partition 1 (Read/Write)
8192K bytes of processor board System flash partition 2 (Read/Write)
4096K bytes of processor board Boot flash (Read/Write)
--- System Configuration Dialog ---
When the following message appears, enter yes to continue:
Step 2
Continue with configuration dialog? [yes/no]: yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Step 3
When the following message appears, enter No to configure all interfaces. Note that if
you enter Yes, your system will not be configured correctly:
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system
Would you like to enter basic management setup? [yes/no]: no
Step 4
When the following message appears, press Enter to see the current interface summary:
First, would you like to see the current interface summary? [yes]:
Any interface listed with OK? value "NO" does not have a valid configuration
Interface
Ethernet0
FastEthernet0
Group-Async1
Serial0
Serial1
Serial2
Serial3
IP-Address
OK? Method Status
171.69.90.18
YES NVRAM
unassigned
YES unset
171.69.90.18
YES unset
unassigned
YES unset
unassigned
YES unset
unassigned
YES unset
unassigned
YES unset
Getting Started
up
administratively down down
down
administratively down down
administratively down down
administratively down down
administratively down down
First-Time Configuration 1-3
Protocol
down
down
Advertisement
Table of Contents
