Table of Contents
Advertisement
If you answer no to IGRP, you will be prompted to configure RIP.
Note
Configure CLNS? [no]:
Configure IPX? [no]: yes
Configure Vines? [no]:
Configure XNS? [no]:
Configure Apollo? [no]:
Configure the asynchronous serial lines for the integrated modems on the modules
Step 11
installed in the access server. (If you want to allow users to dial in through the integrated
modems, you must configure the async lines.)
Async lines accept incoming modems calls. If you will have users dialing in via
modems, configure these lines.
Configure Async lines? [yes]:
We recommend that you do not change the async line speed for modems.
Note
However, for V.110 terminal adapters, we recommend that the speed not go above 19200.
Async line speed [115200]:
Will you be using the modems for inbound dialing? [yes]:
Note
If your asynchronous interfaces will be using the same basic configuration
parameters, we recommend that you group them so that they can be configured as a
group. Otherwise, you will need to configure each interface separately.
Would you like to put all async interfaces in a group and configure them all at
one time ? [yes]
Dynamic IP addresses permit dial-in users to choose a static IP address when they
Note
dial in. If you do not allow dynamic IP addresses, the access server will provide IP
addresses from an IP address pool that you set up later in the next prompt.
Allow dial-in users to choose a static IP address? [no]:
Configure for TCP header compression? [yes]:
Configure for routing updates on async links? [no]:
Note
Make sure the starting and ending addresses of the IP pool are in the same subnet.
Enter the starting address of IP local pool? [X.X.X.X]: 172.20.30.40
Enter the ending address of IP local pool? [X.X.X.X]: 172.20.30.88
You can configure a test user to verify that your dial-up service is working
properly.
Getting Started
First-Time Configuration 1-5
Advertisement
Table of Contents
