Table of Contents
Advertisement
Table 3-24
Step
7
8
9
Verify
To verify you enabled RSVP and RTP on the interface:
•
Tips
If you are having trouble:
•
Configuring IP Networks for Real-Time Voice Traffic (Continued)
Command
5300(config-if)# ip rtp header-compression passive
5300(config-if)# ip rtp compression-connections
number
5300(config-if)# Ctrl-Z
5300#
%SYS-5-CONFIG_I: Configured from console by
console
Enter the show ip rsvp interface command or the show ip rtp header-compression command.
5300# show ip rsvp interface s0:23
interface allocate i/f max
Se0:23
0M
48K
5300# show ip rtp header-compression s2:23
RTP/UDP/IP header compression statistics:
Interface Serial2:23:
Rcvd:
0 total, 0 compressed, 0 errors
0 dropped, 0 buffer copies, 0 buffer failures
Sent:
0 total, 0 compressed,
0 bytes saved, 0 bytes sent
Connect: 20 rx slots, 20 tx slots, 0 long searches, 0 misses
Verify IP connectivity and that data traffic routes using the ping command.
5300# ping
Protocol [ip]: ip
Target IP address: 1.13.23.1
Repeat count [5]: 100
Datagram size [100]: 1000
Timeout in seconds [2]: 0
Extended commands [n]:
Sweep range of sizes [n]:
Type escape sequence to abort.
Sending 100, 1000-byte ICMP Echos to 1.13.23.1, timeout is 0 seconds:
......................................................................
Success rate is 0 percent (0/100)
flow max per/255 UDP
48K
0
/255 0
Purpose
Enable RTP header compression. Enter
passive to compress outgoing RTP
packets only if incoming RTP packets on
the same interface are compressed. If
you do not enter passive, all RTP traffic
is compressed.
Specify the total number of RTP header
compression connections supported on
an interface. The default is 16.
Return to enable mode.
This message is normal and does not
indicate an error.
IP
UDP_IP
UDP M/C
0
0
0
Basic Configuration 3-45
Verify
Advertisement
Table of Contents
