Rear Panel; Optional Phono Preamp - Classe Audio CP-500 - V2.4 Owner's Manual

optional phono preamp

14

Rear Panel

1 Tape Input
Connect the analog outputs of any recording device (analog tape recorder,
digital tape recorder, CD recorder, etc.) you may have to these single-ended
RCA connectors. You may select to hear the output of your recording device by
touching the tape button on the main operational screen of the CP-500.
2 Single-ended (RCA) inputs
These RCA jacks accept right-channel and left-channel (single-ended) inputs from
line-level source equipment such as tuners, CD players, and tape decks. Any of
these inputs may be selected by touching the corresponding button on the main
operational screen of the front panel touchscreen.
To achieve the best possible results, we suggest that you use only high-quality
shielded interconnect cables. Please consult with your local Classé dealer for advice
on the best cables for use in your system.
If you have a turntable you would like to use with the system, an optional phono
preamplifier module is available from your Classé dealer. Once installed in your
preamplifier, the Line 1 input connectors become your phono inputs, and the
phono gain control in the menu system becomes active, allowing you to select
either low gain for all moving-magnet (MM) and high-output moving-coil (MC)
cartridges, or high gain for standard output MC cartridges. (See the section The
Menu System for more information.)
3 Ground terminal
The ground terminal on your integrated amplifier is most often used for the
ground wire of a turntable, assuming you have the optional phono module
installed (see your authorized Classé dealer for more information on this option if
you are interested). Connecting the ground wire from your turntable's tonearm to
this screw terminal usually minimizes any hum or buzzing to which the turntable
might otherwise be susceptible. Your authorized Classé dealer can assist you in
handling this problem if it should arise.